Technical Data - WAGNER FENCE & DECKING SPRAYER Originalbetriebsanleitung

FENCE & Decking SPRAYER
Problem
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose

18. Technical Data

Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. flow rate:
Double insulation:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
Air hose length:
Weight:
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can differ from the specified value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
Cause
•
Coating material in
container running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
Technical Data
170 DIN-s
230 V, ~ 50 Hz
460 W
110 W
150 ml/min
72 dB (A); Uncertainty K = 4 dB
85 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
1.8 m
approx. 2.0 kg
Remedy
➞ Refill
➞ Replace
➞ Change
➞ Turn material volume
adjusting screw to the left (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the left (-)
➞ Clean the diaphragm
➞ Replace the diaphragm
GB
11