bürkert 8630 Betriebsanleitung Seite 107

Entry of the setpoint within the AUTOMATIC mode
After the configuration the Top Control acts as a position controller.
Enter the setpoint as a signal input.
Switch between the display possibilities:
Message on display:
• Actual position of the actuator
• Setpoint of the actuator
• Signal entry for the setpoint
(equivalent to setpoint)
• Internal temperature of the Top Control
Manual opening and closing of the valve within the MANUAL mode
Open the valveantriebs:
Close the valveantriebs:
Message on display:
NOTE Advice Select the
106
(0..100%)
(0..100%)
(0..100%)
(in °C)
The previous display within the AUTOMATIC mode remains active.
display, to ensure that the actual position of the actuator is displayed.
Operating instructions no. 800607