Function Modules (Optional); Mounting - Lenze Global Drive 8200 Vector Montageanleitung

6

Function modules (optional)

Danger!
•
The pins of the FIF interface have a basic isolation (single-insulating distance).
•
Protection against contact in the event of a defective insulating distance can only be ensured
by external measures (e.g. double insulation).
Which function modules can be used?
8200 vector with a function module
8200 vector with two function modules
6.1

Mounting

Function module on interface FIF I
1. Disconnect the controller from the mains and wait for at least 3 minutes!
2. Remove and keep blind cover 
3. Remove and keep the FIF protection cover
4. Plug the function module  on the interface FIF I.
5. Press against the function module until it is snapped into place.
6. Assign the terminals of the function modules (PES: HF- shield connection by
connecting the shield to PE)
L
Function modules (optional)
Possible function modules on FIF I
Possible function modules on FIF I
Possible function modules on FIF II
.

.
Standard I/O
Standard I/O PT
Application I/O
INTERBUS
PROFIBUS-DP
LECOM-B (RS485)
System bus (CAN)
INTERBUS
PROFIBUS-DP
LECOM-B (RS485)
System bus (CAN)
Standard I/O
Standard I/O PT
Function module on interface FIF II
1. Disconnect the controller from the mains and wait for at least 3 minutes!
2. Remove and keep blind cover  .
3. Remove and keep the FIF protection cover
4. Plug the function module standard I/O
5. Press against the function module until it is snapped into place.
6. Assign the terminals of the function modules (PES: HF- shield connection by
connecting the shield to PE)
– Wiring of the terminals "controller inhibit (CINH)":  88
Mounting
E82ZAFS
E82ZAFS100
E82ZAFA
E82ZAFI
E82ZAFP
E82ZAFL
E82ZAFC
E82ZAFI
E82ZAFP
E82ZAFL
E82ZAFC
E82ZAFS
E82ZAFS100
8200vec278

.
 on the interface FIF II.
87
EDK82EV903 DE/EN/FR 2.1