Activating Dual Standby Mode - Philips SRU 4002 Bedienungsanleitung

SRU4002_booklet_v4
Storing favorite STB / TV channels
The Favorites keys are default set to select the first four channels on your STB / TV. If you wish, you can
store other (favorite) STB / TV channels under these keys. Channel numbers containing up to 3 digits can be
stored (e.g. 1, 56, 999). Channel numbers already stored under the keys will be deleted.
1
Keep the OK key and the desired Favorites key pressed simultaneously
for 3 seconds until the LED flashes twice (red) and then remains lit.
– The remote control is now in learning mode.
2
Enter the favorite channel number on the original remote control (e.g. 111).
Be sure to enter each digit within 60 seconds after the previous one.
– After each entered digit the LED flashes twice (red) and the remote control waits for 60 seconds for
the next entry.
– After the last digit is entered, the LED flashes twice (red) and the remote control exits learning mode.
You can always exit learning mode by pressing the OK key.
– The favorite channel is now stored under the Favorites key. Pressing the key will immediately select the
favorite channel.
3
Repeat above procedure for other favorite channels you wish to store under Favorites keys.
Note: Instead of storing favorite channels under the Favorite keys, you can also learn these keys functions from
your original remote control. Up to three key commands (functions) can be stored under each Favorites key.
E.g. switch on TV, switch on STB and select wide screen TV. A combination of key commands and channel
numbers is also possible. E.g. switch on TV, switch on STB and select channel 8.
For this, follow above procedure and enter key commands instead of channel numbers.

Activating Dual Standby mode

By default, pressing the y (Standby) key will switch on your TV. If Dual Standby mode is activated, pressing
this key will switch on your settop box as well.
•
Keep keys y (Standby) and
for 3 seconds.
– The LED flashes two times (red). Dual Standby mode is now activated and
pressing the y (Standby) key will switch on both TV and settop box.
•
Keep keys y (Standby) and
for 3 seconds to deactivate Dual Standby mode.
– The LED flashes two times (green).The y (Standby) key will now only switch on your TV.
Note: If your TV does not switch on when you press the y (Standby) key,
you can switch it on by pressing the +P (Channel up) key.
27-08-2008 13:20
(Guide) pressed simultaneously
(Guide) pressed simultaneously again
Pagina 9
ENGLISH 9