Maintenance Of Bar And Chain; Maintenance Intervals; Storage; Technical Specifications - Texas Pro Chainsaw 300 Betriebsanleitung

1. Check the spark plug as follows.
2. Turn the machines ignition switch to "stop".
3. Remove the spark plug spark plug.
4. Brush the dirt and sawdust from around the spark
plug.
5. Remove it with a spark plug wrench.
6. Check, clean or replace if necessary.
7. Install the spark plug safely and place the spark
plug cap on the spark plug.
Number of new spark plugs: 10011022

Maintenance of bar and chain

Lubrication hole (Fig. 20). Dismount bar and control
on
Bolthole (1) is blocked with sawdust or dirt. Lubricate
with oil / grease.
Swords (Fig. 21). Clean the nose wheel and running
path for dirt. Turn any sword to distribute the wear. A
worn bar can be dangerous to use, and should be
replaced.
Chain (Figure 23-24). Chain should be filed regularly
for best results.
1. Make sure the bar is tightened properly.
2. Use a 4.8 mm (3/16 ") file.
3. File all the teeth with 3-4 coats , so they are
equal, as shown in the drawing.
4. It is necessary to regularly inspect the height
of the teeth if they are too high, they should be
filed with a flat file (provided not).

Maintenance intervals

Part Action
Check /
Screws / Bolts
Tighten
Clean /
Air Filter
Replace
Fuel filter Replace
Sword / Drive
Clean
wheel
Clean / Adjust
Spark Plug
/ Replace
Fuelhose Check
Chain Brake Check

Storage

1. Drain all fuel from tank into a container approved
for gasoline.
2. Start the machine and let it run until all fuel is
used.
3. Allow machine to cool
4. Remove the spark plug
5. Pour 1 teaspoon of 2-cycle oil into the spark plug
hole.
6. Pull slow in recoilline 2-3 times, this distribute
the oil in the engine.
7. Remove the spark plug safely and set spark plug
cap firmly.
8. Store the engine in a dry place
9. Comply with all relevant safety instructions due
to safe storage and handling of gasoline.
Model
Cylinder displacement
Net power
Starter
Fuel
Tank (fuel)
Tank (chainoli)
Chain Lubrecation
Anti-vibration
Weight
Bar
Bar type
Chain type
Chain Breake
Hand Screen
Spiked bumber
Chaincatcher
LWA Guarenteed
Vibrationer
After
Each Use
Every 10. hours
Every 20. hours
Every Need
Every 20. hours
Every 20. hours
Each Use
18

Technical Specifications.

Pro Chainsaw 300
56 cc
2,35 kW (8.000 omdr./min.)
Elektronisk
Olimixed 40:1 (2,5%):
Oktan 95 og 2-stroke oli
550 ml
260 ml
Chainoil SAE 30
Yes
5,1 kg
20" / 50 cm
Oregon Pro-Am .325" 20"
Oregon 0.325 62 Link 1,5
MM Track Wide
Yes
Yes
Yes
Yes
115 dB(A)
Front håndtag: 8,7 m/s
Bag håndtag: 9,9 m/s
K = 1.5 m/s
2
2
2