Low Battery Indicator; Troubleshooting, Maintenance And Care - Mebus 40396 Bedienungsanleitung

TABLETOP SETUP / WALL INSTALLATION
• The external sensor features both a suspension device and a stand.
• Required for wall installation (not included):
Tools
• Drill and drill bit (appropriate for wall anchor size)
• Water level
• Pencil
• Ruler or tape measure
• Line locator
• Suitable installation site: Outdoors, shielded from moisture.
• At the desired installation site for the outdoor sensor, pre-mark 1 drill hole.
• Drill 1 hole in the wall. Insert the wall anchor and screw in the screw. The screw head and ca. 5 mm of
the screw thread should stick out of the wall.
• Caution: Never drill into water pipes or power lines. Use a line locator if necessary.
• Hang up the device.

LOW BATTERY INDICATOR

• Both displays (weather station/sensor) show a low battery indicator
running low.
• The icon reminds you to replace the batteries within the next few days.

TROUBLESHOOTING, MAINTENANCE AND CARE

• Do not install the device near interfering sources (TVs, computers, or similar).
• Avoid placing the device next to or on metal plates.
• We do not recommend using the device in locations such as airports, basements, high-rise buildings
or factories.
• Do not initiate the reception when being in a moving vehicle (e.g. car or train).
• Clean the device with a slightly damp, lint-free cloth. Never use sharp cleaning agents.
Replacing batteries
When the display weakens it is recommended to replace the batteries. Always use new batteries and do
not mix old and new batteries.
28
Fasteners
• 1 screw
• 1 wall anchors
when the batteries are