Battery Low Indication; Operation; Register To A Topcom B29Xx/2800/2820 Base - Topcom butler 2900c MULTI HANDSET Gebrauchsanweisung

Topcom Butler 2900C

4. BATTERY LOW INDICATION

When the battery is empty, the handset no longer carries out operations.
When a battery is completely empty and you have put the handset on the
base unit for a short period of time, the Battery symbol will appear to be
fully charged but this is actually not the case. The battery capacity will
decrease rapidly. We advise you to put the handset on the base unit for 12
hrs so that it can be recharged completely.
• Full battery
• Empty battery
When you are in the middle of a conversation and the battery is almost
empty, the handset will emit a warning signal. Place the handset on the
base unit to charge.

5. OPERATION

5.1 REGISTER TO A TOPCOM B29XX/2800/2820 BASE

You can subscribe 5 handsets to one base unit. By default, each handset
is subscribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• The handset subscription has been removed from the base unit (e.g.
for reinitialisation)
• You want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Topcom Butler 29xx,
2900, 2920 handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the
Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink
rapidly
for one minute. During this minute, the base unit is in register mode and
you must do the
following to subscribe the handset:
• Press and hold the
• The following will appear on the display:
8
and key for 3 sec.
Topcom Butler 2900C