Additional Safety Instructions - Parkside PKGA 16 A1 Betriebsanleitung

GB I E N I
charger that is suitable for a specific type
of battery is used with other batteries.
• In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of fire.
• Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts may
cause burns or fire.
• If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes, seek
medical assistance. Leaking battery fluid
may cause skin irritations or burns.
6) SERVICE
• Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety of
the power tool is maintained.
7) SPECIAL SAFETY DIRECTIONS FOR
BATTERY-OPERATED TOOLS
• Ensure that the device is switched
off before inserting the battery.
Inserting a battery into a power tool that
is switched on may result in accidents.
• Recharge the batteries indoors
only because the battery charger
is designed for indoor use only.
Risk of electric shock.
• To reduce the electric shock haz-
ard, unplug the battery charger
from the mains before cleaning
the charger.
1 0
CY
• Do not subject the battery to
strong sunlight over long periods
and do not leave it on a heater.
Heat damages the battery and there is a
risk of explosion.
• Allow a hot battery to cool before
charging.
• Do not open up the battery and
avoid mechanical damage to the
battery. Risk of short circuit and
fumes may be emitted that irritate
the respiratory tract. Ensure fresh air
and seek medical assistance in the event
of discomfort. After eye/skin contact,
rinse the affected areas with water or a
neutraliser and consult a doctor.
• Do not use non-rechargeable
batteries. This could damage the appli-
ance.

Additional safety instructions

Warning! Sawing or sanding
can result in the formation of
hazardous dusts (e.g. arising
from materials with paints con-
taining lead, materials contain-
ing asbestos, metals or some
wood types) which can present
a hazard to the operator or
persons in the vicinity. Make
sure that the workplace is well
ventilated. Always wear safety
goggles, safety gloves and
respiratory protection. Attach a
dust extraction system.
1) SPECIAL SAFETY INFORMATION FOR
THE CORDLESS COMBINATION TOOL
Use the additional handles deliv-
•
ered with the appliance. The loss of
control can result in injuries.
• Hold the electric tool by the insu-