Setting Up The Receiver; A) Connecting The Receiver; Receiver Connection - ModelCraft FS-T6 Bedienungsanleitung



11. Setting up the Receiver

a) Receiver Connection
On its right hand side, the receiver (see figure 8, item 1) offers the option of connecting up to 6 servos with JR plug
connectors:
The receiver battery is connected either to a free slot or the top slot (BAT).
When connecting servos and speed controllers, always make sure of correct polarity of the plug connectors.
The impulse line of the servos (depending on manufacturer yellow, white or orange) must be connected to
the left (inner) one of the three adjacent plug-in contacts. The plug contact for the negative line (black or
brown, depending on the manufacturer) must be connected to the right (outer) pin contact.
The receiver outputs are assigned as follows:
Channel Output
1 CH1
2 CH2
3 CH3
4 CH4
5 CH5
6 CH6
- BAT
Figure 8
Helicopter
Roll servo
Pitch servo
Throttle servo
Flight controller
Tail servo
Gyro sensitivity
Pitch servo
Battery connection*
Motor model plane
Aileron servo
Elevator servo
Throttle servo
Flight controller
Rudder servo
Additional channel 5
Additional channel 6
Battery connection*
73