Dirt Devil m 8030 r9 antiinfective Bedienungsanleitung Seite 28

3 Operating
1
2
1
1
1
28
1. Push on the desired nozzle, ZChapter 2.3, "Using other
nozzles (accessories)".
2. Pull the cable holding the plug (Fig. 1/15) until the
yellow mark (Fig. 11/1) is reached.
WARNING:
2
If the red mark (Fig. 11/2) is visible, then retract the cable
again until it is no longer visible, ZChapter 3.2,
Fig.11
"Switching off and retracting the power cable". Otherwise
the cable can break off. There is a risk of electric shock.
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 12/1).
4. Turn on the suction using the suction controller (Fig. 12/
2).
5. Adjust
depending on the type of flooring:
Fig.12
- Hard floor (Fig. 13/a)
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 13/b)
a
Long and short pile carpets, runners, etc.
b
6. To vacuum, pull the cylinder vacuum cleaner behind
Fig.13
you like a sledge. When vacuuming, observe the
corresponding
manufacturer.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 14/1), e.g. to release
curtains that have been sucked in.
Fig.14
the carpet/hard floor
recommendations
switch (Fig. 13/1)
of the flooring