Wolf TRK Montageanleitung Seite 33

3061284_1206
Collector installation
Push the retaining clip removed when you unpacked the collector up to its first locking
position onto the l.h. connection, so that it protrudes approx. 2 cm from the casing.
The retaining clip is designed to adjust the space between the collectors and to
secure them.
Installing additional collectors
Unpack the next collector and carry it up onto the roof, then lay it again, like the first
one, onto the mounting rails.
NB Preassemble the threaded plate, washer and hexagon screw for the
next collector to the right at the bottom of the mounting rail.
Then slide the second collector to the right towards the first one, so that the connections
at the top are joined together (casing clearance approx. 2 cm, determined by the clip)
and that the foot profiles are abutting each other.
Carefully push the clip in so far that it no longer protrudes from the casing.
Secure the second collector to the rails at the top and bottom.
Repeat the above procedure to install additional collectors.
TRK
33