Siemens SINUMERIK 810D Handbuch Seite 170

DNC Plant/DNC Cell (FBDN1)
10 Konfiguration
;
NCProgrammStart2=
;
NCProgrammStart3=
;
NCProgrammEnd1=M30
;
NCProgrammEnd2=M17
;
NCProgrammEnd3=
[DIALOGFUNCTION]
;---DlgScanLines---: (number of the signifcant lines, beginning with line 1)
DlgScanLines=10
;---Parameters in special ASCII-Character- Words---
;---DlgID---: (Name of the dialogue file)
DlgID=%MPF9999
;---DlgIDSend---: (Name of the answer file (list, error), sent from DNC_NT to
machine)
DlgIDSend=%MPF9998
;---DlgSendEnd---: (Program End for the answer file (list, error), sent from DNC_NT
to machine)
DlgSendEnd=M30
;---DlgSendCmd---: (character which indicades to download a file with releaseID)
DlgSendCmd=(S)
;---DlgSendTcCmd---: (character which indicades to download a file with trialcutID)
DlgSendTcCmd=(ST)
;---DlgReceiveCmd---: ( character which indicades to upload a file from machine to
DNC)
DlgReceiveCmd=(R)
;---DlgSendListCmd---: ( character which indicades to download a filelist of the
machinedirectory in DNC)
DlgSendListCmd=(SL)
;---DlgWpdMark---:
DlgWpdMark=WPD
;if it is impossible to write MPF, SPF, TOA ... you can define a character followed
by a number
;Y001 = MPF, Y002 = SPF, Y003 = TOA ... ordernumber as defined in Databasetable
NCDATATYPE
DlgExchangeCNCType=
;in exchange for * if it is impossible to write *, eg. X999 (only for use with
DlgSendListCmd!)
DlgExchangeWildcard=
;DlgConverter=DNCDlgI.DNCCntrl
DlgConverter=
DlgSubNumber=0
;CutFromName=
;------- The following parameters are directly corresponding to MiniDNC ------------
---------------
;
;MiniDNC
;#####################################
; [COM]
; #1210
; #1211
; #1401
; #1402
; #1403
; #1501
; #1502
; #1503
; not existent
; [SEND]
; #1201
; #1202
; not existent
; not existent
; #1205
; #1207
; #1204
; #1206
; #1209
; #1208
FBDN1/10-166
(allows to change the shortcut of an workpiece directory)
DNC_NT-2000
[COM] XONChar
[COM] XOFFChar
[COM] ComPort,
[COM] FlowCtrl,
[COM] BaudRate, Parity, ByteSize, StopBits
[COM] ComPort,
[COM] FlowCtrl,
[COM] BaudRate, Parity, ByteSize, StopBits
[COM] binary
[SEND] ProgramStart
[SEND] ProgramEnd
[SEND] CommentStart
[SEND] CommentEnd
[SEND] HeaderChar
[SEND] TrailerChar
[SEND] HeaderSize
[SEND] TrailerSize
[SEND] SpacerChar
[SEND] SpacerSize
or Paramter: [SEND] SendBaudRate
© Siemens AG 2011 All Rights Reserved
Motion Control Information System DNC (FBDN) - 09/2011
09/2011