Resetting The Total Lamp Timer - Sharp XV-Z12000 Anleitung

Resetting the TOTAL LAMP TIMER

● Resetting the lamp timer
Reset the lamp timer after replacing the lamp.
■ It is recommended that the lamp (sold separately) be replaced after approximately 1,900 cumulativehours of use
or when you notice a significant deterioration in the picture and color quality. The lamp usage time can be checked
with "Lamp Timer" in the "Options" menu on the menu screen.
■ For lamp replacement, please consult your nearest Authorized SharpVision Service Center or Dealer.
■ The actual lamp service life may be less than 2,000 hours depending on the environment in which the projector is
used.
Maintenance indicator
Normal
Temperature
warning
Off
indicator
Blue on*
Blue
Lamp blinks
indicator when the
lamp is
active.
Power Blue on*/
indicator Red on
* Blue is off when "LED" is set to "OFF".
Condition
The LAMP REPLACEMENT
indicator lights up red, and "LAMP"
and " " will flash in yellow in the
lower-left corner of the picture.
A significant deterioration of the
picture and color quality occurs.
The power will automatically turn
off and the projector will enter
stand-by mode.
"LAMP" and " " will flash in red in
the lower-left corner of the picture,
and the power will turn off.
1
Connect the power cord.
• Plug the power cord into the AC socket
of the projector.
2
Reset the lamp timer.
• While holding down , " and | on
the projector, press on the projector.
• "LAMP 0000H" is displayed, indicat-
ing that the lamp timer is reset.
Info
• Make sure to reset the lamp timer only
when replacing the lamp. If you reset the
lamp timer and continue to use the same
lamp, this may cause the lamp to become
damaged or explode.
Condition
Abnormal Abnormal
• Blocked air intake
The internal
• Cooling fan break-
temperature is
Red on/
abnormally high.
Standby
• Internal circuit failure
• Clogged air intake
• Burnt-out lamp
Red on/ The lamp does
• Lamp circuit failure
Standby not illuminate.
• The lamp usage
Red Lamp replace-
blinks ment time.
The power
• The exhaust vent
indicator blinks
Red blinks
in red when the
projector is on.
Problem
• Lamp has been used for over 1,900
hours.
• Lamp has been used for over 2,000
hours.
21
Problem
• Relocate the projector to an area
with proper ventilation.
• Take the projector to your nearest
down Authorized SharpVision Service
Center or Dealer for repair.
• Clean the ventilative holes.
• Carefully replace the lamp.
• Take the projector to your nearest
Authorized SharpVision Service
Center or Dealer for repair.
• Please exercise care when
replacing the lamp.
time has exceeded
1,900 hours.
• Securely install the cover.
• If the power indicator blinks even
when the exhaust vent cover is
securely installed, contact your
cover is open.
nearest Authorized SharpVision
Service Center or Dealer for
advice.
• Purchase a replacement lamp unit
(lamp/cage module) of the current
type BQC-XVZ100005 from your
nearest Authorized SharpVision
Service Center or Dealer.
• Replace the lamp. If you wish, you
may have the lamp replaced at your
nearest Authorized SharpVision
Service Center or Dealer.
XV-Z12000
Possible Solution
Possible Solution