Sharp XG-P25X Service Anleitung Seite 33

No. Adjusting point
25 Color system 1. Receive the color bar sig-
performance
check
26 Video system 1. Receive the monoscope
performance
check
27 Audio system
performance
check
28 RGB 1. Receive the RGB signal.
performance
check
29 Off-timer
performance
check
30 Thermistor 1. Heat the thermistor using a
performance
check
31 Automatic 1. Receive the PHASE check
synchronization
32 Keystone
correction
performance
check
33 Factory settings 1. Select the following subject.
Adjusting conditions
nal.
pattern signal.
dryer.
pattern signal.
Group; SSS
Adjusting procedure
» In the process mode and select L1. Check the color
and tint.
» In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
» In the process mode nad select L3. Check the bass,
treble and balance.
» In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
» In the process mode and select OFF. Make sure that
the off-timer starts with "5" (minutes), counts down
each minute in 1 second, and turns off the set at "0".
» Make sure the "TEMP" is displayed.
» Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
» Make sure the keystone correction functions well.
» Make the following settings.
Process
Remote controller setting
adjustment
S4 "Factory setting 4" for USA and Canada
"Factory setting 3" for Europe, Austraia
S3
and Hong Kong
33
XG-P25X