Assembly / Disassembly; Assembling The Meat Grinder - Silvercrest SFW 250 A1 Bedienungsanleitung

To avoid the risk of accidents and
injuries:
• Never put your hand into the openings of the ap-
pliance. Do not insert any objects of any kind
into the openings – except for the appropriate
stodger and the foodstuff to be processed. If you
do, there will be a serious risk of accidents!
• Unplug the appliance from the power source be-
fore attaching or removing accessories.
• Do not leave the appliance unsupervised when it
is ready for use. To avoid it being switched on
accidentally, always unplug the appliance after
use or during breaks.
• Use only original accessories for this appliance.
Other accessories may not meet the safety
requirements.
• This appliance is not intended for use by individuals
(including children) with restricted physical, physio-lo-
gical or intellectual abilities or deficiences in
experience and/or knowledge unless they are
supervised by a person responsible for their
safety or receive from this person instruction in
how the appliance is to be used.
• Children should be supervised to ensure that
they do not play with the appliance.
• Never operate the appliance in a no-load condi-
tion. This could irreparably damage the
appliance.

5. Assembly / Disassembly

IMPORTANT: All accessories are coated with
a thin film of oil to protect them from corrosion.
Therefore carefully clean all of the parts before
using the appliance for the first time, as com-
prehensively described on chapter "8 Clea-
ning". After subsequent usage, always apply a
light coating of cooking oil to the metallic
components.
a) Assembling the meat grinder
Unfold the fold-out side. There you will find the
step-by-step illustrations for assembling the appliance.
• Place the transport screw
t
casing .
• Place the spring
• Then place on the cross blade
sharp side points away from the spring
Caution:
i
The cross blade
Important!:
The appliance will be damaged if the cross blade
i
is inserted the other way around!
• Select the desired cutting disc. The cutting discs
that are not required can be stored in the small
compartment on the appliance (Fig.
To open it, press on the symbol
The cover can now be opened. Insert the two
unrequired cutting discs.
• Insert the selected cutting disc
grinder casing
o
cutting disc
grinder casing
• When everything has been correctly assembled,
screw the ring clamp
- 3 -
y
into the mincer
u
onto the transport screw
i
so that the
is very sharp! Risk of injury!
on the cover.
o
into the meat
t
, so that the indentations on the
lie on the fixing points in the meat
t
.
a
on until it is handtight.
y
.
u
.
).