2. ERROR lamp (Red), PAPER lamp (Red)
Indicates an error by illuminating or blinking the lamps.
Error
Memory check error
Head-up
Head overheat
Paper near end
Paper end
Macro execution wait
<Error Details>
Head-up
Head overheat
Paper near end
Paper end
Display
ERROR Lamp
Quick blinking
ON
Blinking
OFF
OFF
Slow blinking
----- Occurs when the head-up lever is raised. The printer cannot
feed the paper or print. The parallel interface outputs BUSY
and FAULT, and serial interface DTR, respectively.
----- If the temperature of the printing head rises (About 65°C or
more), in order to protect it against overheating, a printing
head temperature sensor will be activated to stop printing.
The parallel interface outputs BUSY and FAULT, and serial
interface DTR, respectively. If the temperature drops (About
60°C), printing will be automatically resumed.
----- If the diameter of the paper roll decreases, the paper near
end sensor will react to inform you that the paper roll is
running out. See "4.12 Paper Near End Function".
----- If the paper roll runs out, the paper sensor near the printing
head will react to stop printing. See "4.11 Paper End
Function".
— 29 —
PAPER Lamp
OFF
Cannot be reset
OFF
Lower the head-up lever.
Automatically reset by a
OFF
temperature drop
Set a new paper roll after a
ON
print stop.
ON
Set a new paper roll.
OFF
Press the FEED switch.
Reset