Inhaltsverzeichnis
Werbung
4.2.2 Installing the Battery Pack
1
With the labeled side of battery pack facing up, connect the battery
connecter.
2
Insert the battery pack into the battery compartment.
(Tuck the battery connecter tidily in the extra space of the compartment.)
3
Place the battery cover back over the compartment by sliding it from the
back of the printer. (Exercise care not to bite the battery leads.)
4
Be sure to install the battery cover after the battery pack is replaced.
CAUTION:
• When connecting or disconnecting the battery connecter, be sure to hold the
connector shells. Never pull the battery leads.
• Do not give the battery pack a severe jolt or drop on a hard surface.
• To prevent the battery pack from bulging, heat build-up, or bursting, never use any
battery pack other than the supplied battery pack.
• Never remove the battery pack from the printer and use it for driving any other
device. Such a practice may cause damage to the battery pack or the target device.
• Be sure to install the battery cover after the battery pack is replaced.
Label
Battery pack
Battery connecter
— 12 —
Werbung
Inhaltsverzeichnis
