Selecting Inputs For Main Monitor; Selecting Inputs For Spot Monitors; Interface Selection; Selecting A Camera For Control - Siemens CKA4820 V2 Benutzerhandbuch

SISTORE AX configuration

15.3.2 Selecting inputs for main monitor

15.3.3 Selecting inputs for spot monitors

15.3.4 Interface selection

15.3.5 Selecting a camera for control

70
Siemens Building Technologies
Fire Safety & Security Products
To select SISTORE AX inputs for the main monitor, use the following key
combination on the control unit:
Key sequence
To select SISTORE AX inputs for the spot monitor, use the following key
combination on the control unit:
Key sequence
or
or
or
To select an interface use the following key combination on the control unit:
Key sequence
or
2
SISTORE AX may not be selected for connection to both interfaces COM1 and COM2 at the same
time.
If SISTORE AX is selected in the configuration menu of the control unit for both interfaces, then the
error message Config. - ERROR!! appears on the display.
Using this function you can select the camera to be controlled, also from the
multiple split display.
Key sequence Description
Selection of camera 5 for PTZ control.
Description
Selection of SISTORE AX input (here no. 5)
1. Press the desired key X (keys 1-9, 0; two-digit input is also possible:
00-99).
2. Press AX key.
The data is now transmitted and the selected channel is switched.
Description
Selection of SISTORE AX input (here no. 5)
1. Press the desired key X (keys 1-9, 0; two-digit input is also possible:
00-99).
2. Press F1, F2, F3 or F4 key.
The data is now transmitted and the selected channel is switched to
the selected spot monitor 1, 2, 3 or 4.
Description
Switching between interfaces
1. Keep POS key depressed.
2. Press either key 1 (COM1) or key 2 (COM2).
03.2009