Sonyset Controls - Bosch MIC440 Installationshandbuch

MIC440 Explosion Protected CCTV Camera System| Installation and Operation Manual
frame rate and gain etc. normal running auto everything, and another set-up for
ANPR, with a specified frame rate and gain etc.
These states could then be toggled by calling them up with an
command.

SonySet Controls

SonySet Preset Number
This is where the SonySet Preset number is selected, there are 10 options
available relating to 10 complete camera setups.
Get Preset from MIC
This process will query the MIC for the table number as specified in the SonySet
Preset Number list. Each valid command and value will be shown in the table. If
any data is incorrect or the command does not exist the Sony Command column
will display "Invalid". It is not advised to reprogram a MIC with any "Invalid"
commands.
Send Preset to MIC
This will read through the entire table checking for valid commands and respective
values indicating any discrepancies, and then form the commands to send the data
to the MIC. The data is stored to the preset number as indicated in the SonySet
Preset Number in list.
Bosch Security Systems
Execute this Preset
This will send a command to the MIC to read the commands from the preset
Execute SonySet number in SonySet Preset Number list in memory and send them on to the Sony
module. This will only send commands stored not the ones in Camset, so to test a
Setup first use
Load Table from File to MIC
It is also possible to Load a complete table of all 10 presets directly into the MIC
from a file. This will prompt the user to open an XML file containing all of the
information required. The information will not be displayed in the table display, it
will simply be sent straight to the MIC.
Save Table from MIC to File
This creates the files that can be used by the feature above. First it will prompt for
a file location to store and if valid, poll the MIC for each command of each preset
and store all of the information to an XML file.
Using the
complete SonySet table from one MIC to another to easily setup a site with the
same configuration.
Clear Table
This clears the table in Camset and will not do anything to the data stored at the
location in memory in the MIC itself. To clear a MIC table, use this function and
then Send Preset to MIC.
Issue 7
Send Preset to MIC then Execute this
Save and Load file functions as above means it is possible to copy a
EN | 44
Preset.