Continuous Measurement - TOOLCRAFT LDM-70BT Bedienungsanleitung

4. After each measurement, the laser is deactivated and must be
reactivated using the button
Delete the measurement by pushing the button
You can also push the side MEAS button (3) to initiate the
measuring procedure.
g) Continuous measurement
In continuous measurement mode, measurement is conducted
continuously. This means that you can point the target laser at various
objects without first starting a new measurement.
Measurements are taken in 0.5 second intervals and the values
are shown on the display. Measured values are not saved to
the memory.
The device can take a maximum of 100 continuous
measurements. When 100 continuous measurements are
reached, two audible signals sound and the target laser is turned
off.
1. Turn on the device.
2. Push and hold the
switches to continuous measurement mode.
3. The device automatically starts taking measurements and the values
are shown on the display.
» The measured distance is shown.
» In addition to the currently measured distance, the display shows
the maximum (MAX) and minimum (MIN) values.
4. You can pause continuous measurement mode at any time by
pushing the button
» The target laser will be turned off.
» Push the button
distance measurement mode.
54
before the next measurement.
button (5) for approx. 1 second. The device
.
to switch the device back to individual
.