Output Signals; Switching Outputs; Twopoint Mode - Switch Point Setting (Sp) - HYDAC ELECTRONIC HNS 3000 Bedienungsanleitung

HNS 3000 IO-Link

10 Output Signals

10.1 SWITCHING OUTPUTS

The HNS 3000 IO-Link has 2 switch outputs whose switching behaviour (window mode or
twopoint mode) is parameterisable.
In addition to the IO-Link Smart Sensor Profile Specification, a switch and switch-back
delay can be set in HYDAC IO-Link sensors.
CAUTION
Exceeding or falling below the measuring range leads to a limitation to the
corresponding upper or lower limit of the measuring range.
10.1.1

Twopoint mode - Switch point setting (SP)

One switch point and one switch-back point can be set for each switching output. The
particular output will switch when the pre-set switch point is reached and then switch back
when the level drops below the switch-back point.
Example for switch point 1 (N/C and N/O function):
Measured
Normally open function
Normally closed function
Abbreviations:
Note:
• It is only possible to set the switch point (SP) if it is higher than the respective
switch-back point (RP).
Version 2016/10/25
value
On
Off
On
Off
"SP1", "SP2" = switch point 1 / switch point 2
"RP1", "RP2" = switch-back point 1 / switch-back point 2
"HNO", = N/O when hysteresis function is active
"HNC" = N/C when hysteresis function is active
HYDAC ELECTRONIC GMBH
page 12
Part No. 669945