Parameterisation; Output Settings; Switching Outputs - HYDAC ELECTRONIC EDS 820 Bedienungsanleitung

EDS 820 IO-Link

9 Parameterisation

The pressure switch can be parameterised via the device keys or via the IO-Link interface
by means of any IO-Link compatible master configuration tool (according IO-specifications
V1.1). Supports IO-Link specifications V1.0
Should the read parameter sets from the device not be accepted, we recommend to carry
out a plausibility check of the parameter set.
For detailed information on IO-Link device parameters, factory defaults, process and
diagnostic data, supported standard system commands as well as additional HYDAC
device specific system commands for the various product versions (part numbers), please
refer to the corresponding IODD (IO Device Description).
You will find the link for download of the IODD on our homepage at
→Products→Sensors→Product search
(http://www.hydac.com/uk-en/products/sensors/show/Material/index.html)
Entering the part number (9xxxxx) the corresponding ZIP file appears

10 Output settings

10.1

Switching outputs

The EDS 820 IO-Link has 2 switch outputs whose switching behaviour (window mode or
twopoint mode) is parameterisable.
In addition to the IO-Link Smart Sensor Profile Specification, a switch and switch-back
delay can be set in HYDAC IO-Link sensors.
CAUTION
Exceeding or falling below the measuring range leads to a limitation to the
corresponding upper or lower limit of the measuring range.
Edition: 2016-01-13
All manuals and user guides at all-guides.com
HYDAC ELECTRONIC GMBH
7
E
Part No.: 669916