Possible Cause - Topcom BABYTALKER 3500 SEDS Bedienungsanleitung

CAUTION
Risk of hazard due to incorrect repairs
Incorrect repairs can expose users to serious hazards and cause damage to the equipment.
• Never attempt to modify or repair the equipment.
• Always have repairs to equipment or cables performed by a specialist or the service centre.
• If you suspect that the equipment is damaged (for example, if it has fallen on the floor), have it
checked by a specialist before you use it again.
11.2 Problem Causes and Solutions
The following table is intended to help you localise and solve minor problems.
Problem
The rechargeable
battery pack of the
parent unit does not
charge
Parent unit does not
switch on (display
remains blank)
'NOT LINKED' appears
on the parent unit
display
The parent unit does
not reproduce the
sounds picked up by
the baby unit
Limited range and
interference during
transmission
The equipment emits a
high-pitched whistle
11.3 Registering the Parent Unit with the Baby Unit
If the night light of the baby unit blinks and/or no connection can be established between the parent unit and the
baby unit (blinking green LED
• Check that the AC mains adapter of the baby unit is connected and plugged into a mains
receptacle and that the batteries in the parent unit are charged.
– Unplug the AC mains adapter of the baby unit from the mains receptacle and remove the batteries from
the parent unit.
– Press the On/Off switch
the mains receptacle.
The baby unit will start up in registration mode.
– Release the On/Off switch
– Press the On/Off switch
The parent unit will start up and the 2 red volume LEDs
12

Possible cause

Charging station plug not connected
Dirty contacts
The rechargeable battery pack is
defective
The rechargeable battery pack is not
charged
Equipment defective
Baby unit not switched on
The parent unit and baby unit are too
far apart
The parent unit is not registered with
the baby unit
The volume setting of the parent unit
may be too low or switched off.
The microphone sensitivity of the baby
unit may be set too low.
The range of the equipment depends
on the surroundings.
Steel structures and concrete walls
can impair transmission.
The parent unit and baby unit are too
close together
on the parent unit), the parent unit needs to be registered with the baby unit.
21
of the baby unit and hold it pressed while plugging the AC mains adapter into
12
. The night light 2
12
of the parent unit and hold the button pressed while installing the batteries.
29
Babytalker 3500 SEDS
Connect plug
Clean the battery terminals and
charging station contacts with a soft
cloth
Replace the battery pack
Charge the battery pack
Contact customer service
Switch on the baby unit
Reduce the distance between the
parent unit and the baby unit
Register the parent unit with the baby
unit (see "11.3 Registering the Parent
Unit with the Baby Unit"
Increase the volume setting of the
parent unit
Check the VOX sensitivity and the
volume setting of the parent unit and
increase if necessary.
Avoid obstacles as much as possible.
Increase the distance to at least
2 metres
of the baby unit will blink for 60 seconds.
will blink. Release the On/Off switch
17
Solution
.
29