Kärcher CV 60/2 RS Bp Handbuch Seite 17

 Pull out the spring plug.
 Pull out the pin.
 Remove the side brush.
 Install new brush in reverse sequence.
Adjust the chain tension of the trav-
el drive.
If the chain can be moved more than 6 mm
to each side, it must be retensioned.
 Remove the bottom front panels.
A blinking battery display indicates the fol-
lowing faults. The time sequence of the
Number of flashes Fault
1 Battery discharged oder battery cable damaged.
2 Cable to drive motor interrupted.
3 Cable to drive motor shorted.
4 Deep discharge power not reached
5 --
6 Drive attempt while charger is connected.
7 Fault in drive pedal.
8 Control faulty.
9 Parking brake fault.
10 Shorted connection on battery connection.
Once every 5 sec- Control idle.
onds
Blinking signal Fault
Blinks red Battery poled or is not connected
Blinks green and Cable connection between battery and charger is
yellow. poor.
Battery defective
 Before restarting the charger, pull the
plug out of the socket, wait until the
charge status indicator shuts off and
plug the mains plug back in.
 Loosen the 5 fastening screws of the
gear motor.
 Slide the gear motor up until the chain
tension is correct.
 Tighten the screws.
Danger
Risk of injury! Before carrying out any tasks
on the machine, set the main key to "0" and
remove it. Pull out the battery plug.
Errors shown by the battery indicator
blinking segments indicates the type of
fault.
Faults shown by the charge status indicator (Bp model only)
Faults
Remedy
Check battery cable, charge battery.
Inform Customer Service
Charge battery.
--
Remove the power plug from the charger and hook the
holder into the appliance.
Release the drive pedal prior to turning on the appliance.
Inform Customer Service
Check the terminals on the batteries.
Turn the main switch to "0" and turn it back to "1".
Remedy
Check battery cable for correct sitting.
Check battery cable for correct sitting.
Check whether the connection to the battery was interrupt-
ed during the charge process.
Check battery.
6
-
EN
Note
Suction turbine will continue to run for a
while after switch-off. Carry out mainte-
nance tasks only after the suction turbine
has come to a halt.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
17