SICK DME4000 Betriebsanleitung Seite 77

Operating Instructions
DME4000
3.3.5
Speed
Speed
The "Speed" function makes output via both switching outputs MF1 and MF 2 possible when the pa-
rameterized speed limit is exceeded.
The switching hysteresis is fixed ± 0,1 m/s.
On
3.4.5.1
Limit
(default)
Limit
Off
On
3.3.5.2
Sign
(default)
Sign
Off
3.4
MF2
MF2
Parameterizable output
3.4.1
Act.State
Active State
Aktiv 1
Aktiv 0
3.4.2
Function Function
Distance siehe 3.4.3
Service (default) siehe 3.4.4
Monitor
3.4.3
Distance Distance
6)
MF2 is used as distance switching output.
Function:
Active
Not active
Lower
limit
3.4.4
Service Service
6)
Freely settable status messages in "OR" link, which provide information about the sensor state.
3.4.4.1
Laser
Laser
8014584/US35/2011-07-07
Menu Structure
Aktiv
Range: 0,1 ... 9,9 m/s
–
Parameterized speed limit is exceeded and movement
direction "+".
Measured value becomes bigger;
Movement direction "-": Measured value becomes
smaller;
Movement direction "+/-": Measured value in both
directions
–
Low Active (default)
LOW
HIGH
(Only SSI variant): Is displayed when the monitor interface is set to On under
3.1.4.
Upper
limit
Active
On (default) Pre-failure message
laser diode
Off –
© SICK AG • Industrial Sensors • Germany • Subject to change without notice
Nicht aktiv
Range: 0 m/s
Parameterized speed limit is not
exceeded.
High Active
HIGH
LOW
Not active
Laser OK
Chapter 3
77