SICK DME4000 Betriebsanleitung Seite 75

Operating Instructions
DME4000
3.1
DeviceNet DeviceNet
3.1.1
Baudrate Baud rate
125 (default)
3.1.2
Bus Address
BusAddress
Addr. 06 (default)
3.1
CANopen CANopen
Baud rate
125 kBd (default)
3.1.2
Node-ID Node-ID
ID: 006 (default)
3.2
Serial Serial
3.2.1
Baud rate
BaudRate
19.2 (default)
3.2.2
Data
Data
7,e,1
8,e,1
8,n,1 (default)
For a detailed description, see Chapter 8.2.2 "RS 422".
3.3
MF1 MF1
Parameterizable input or output.
3.3.1
Act.State
Act.State
Operation
Aktiv 1
Aktiv 0
*) When using as input, see Chapter 9 "Appendix".
3.3.2
Function Function
Distance
(default) see 3.3.3
Service see 3.3.4
Preset
Sleep Mode
Monitor
8014584/US35/2011-07-07
Menu Structure
Setting the baud rate (125, 250, 500 kBaud)
Setting the DeviceNet address (range 0 ... 63)
Setting the baud rate (125, 250, 500 kBaud, 1 MBaud)
Setting the Node-ID (range 001 ... 127)
Baud rate for RS 422 parameter interface (max. 115.2 kBd)
Baud rate for SSI monitor interface (max. 38.44 kBd)
7 data bits, even parity, 1 stop bit
8 data bits, even parity, 1 stop bit
8 data bits, 1 stop bit
Low Active
LOW (or not switched*))
HIGH
Overwriting of the offset value
Offset = Preset value – current measured value
For a function description, see "Explanation of Terms – Preset".
Laser off, measured value = 0, acknowledgment via Ready status
For a function description, see "Explanation of Terms – Sleep Mode".
(Only SSI variant): Is displayed when the monitor interface is set to ON under 3.1.4.
© SICK AG • Industrial Sensors • Germany • Subject to change without notice
High Active (default)
HIGH
LOW (or not switched*))
Chapter 3
75