Installation - Klarstein 10028328 Anleitung

• The installation position of dishwasher should be near the existing inlet and drain hoses and power cord.
• One side of the cabinet sink should be chosen to facilitate the connection of drain hoses of the dishwasher.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be
positioned to the right or the left to facilitate proper installation.
Power Cennection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only insert the
plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug , replace the socket, rather than using a adaptors or the like as they
could cause overheating and burns.
Watter Supply Hose
The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be
reused. Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum consult
our Service Department for advice.
• Connection: Pull The safety supply hoses completely out from storage compartment
located at rear of dishwasher. Turn water fully on before starting the dishwasher. Tigh-
ter the screws of the safety supply hose to the faucet with thread 3/4inch.
• Disconnection: Turn off the water. Unscrew The safety supply 2 hose from the faucet.
IMPORTANT: Connect the cold water supply hose to a threaded 3/4(inch) connector
and make sure that it is fastened tightly in place. If the water pipes are new or have not
been used for an extended period of time, let the water run to make sure that the water is clear and free of
impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the
appliance.
Drain Hose
Insert the drain hose into a drain pipe with a minimum diameter
of 40 mm, or let it run into the sink, making sure to avoid bending
or crimping it. The top of the ho se must be less than 1000 mm.
Use the special plastic support that comes with the appliance.
The free end of the hose must be at a height lower than75cm
and must not be immersed in water to avoid the back flow of it.
IMPORTANT: The special plastic hose support must be solidly
fastened to the wall to prevent the drain hose from moving and
allowing water to spill outside the drain.

Installation

26