Installation; Installation Preparation - Klarstein MELVILLE 3 Bedienungsanleitung

EN
62

INSTALLATION

WARNING: Danger of electric shock
Disconnect electrical power before installing dishwasher. Do
not, under any circumstances, cut or remove the earthing
connection from the power cord. The installation of the pipes
and electrical equipments must be done by professionals.

Installation preparation

The installation position of dishwasher should be near the existing water inlet tap
and drain outlet and power socket. One side of the cabinet sink should be chosen
to facilitate the connection of drain
hose of the dishwasher.
Positioning the appliance
Position the appliance in the desired location. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is
equipped with water supply and drain hoses that can be positioned to the right or
the left to facilitate proper installation.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the
dishwasher to the appropriate power supply. Use the required fuse 10 amp, time
delay fuse or circuit breaker recommended and provide separate circuit serving
only this appliance.
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those on
the rating plate. Only insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the socket, rather than using a adaptors or the
like as they could cause overheating and burns.
Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time,
let the water run to make sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
Please note: If the supplied hose cloes not fit your tap, please contact your local
plumbing supply center where adapters are available for purchase.