Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Starting locomotive operation
GB
Unwrap model: Take out loco cautiously using
foil (fig. 1).
Very important!
Before taking into service your model these
bearings of the coupling rods must be oiled
as otherwise there would be the risk of bad
running qualities or damage on the locomotive
(see fig. 6).
4
Operating instructions: Before use is advisable
to let the loco go around about 30 minutes for-
wards and 30 minutes backwards without load, to
obtain an optimal circuit and best tractive power.
The smallest radius this model should run is R2 of
the ROCO, –N– track system (R2 = 228,2 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 25093, Roco track cleaning van, or item no.
10002, Roco track cleaning rubber, for remo-
ving heavy dirt.
Maintenance of the model
GB
To enjoy your locomotive for a long time, it is
necessary to service it regularly (i.e. after it has
been in operation for approximately 30 hours).
1. Cleaning of wheel contacts: Wheel contacts
easily get dirty on tracks which are not entirely
clean. Use a small brush to remove dirt from
spots marked in fig. 4. Prior to cleaning the remo-
ve loco body (fig. 2).
µ Assembly
2. Lubrication: Apply tiny oil drops to spots
marked in fig. 6. Prior to lubrication dismantle
locomotive (fig. 2). We recommend using item no.
10906, Roco oiler. For lubrication the gear-parts
(e.g. cog-wheels, worm) we would recommend
our Roco special grease (item No. 10905).
Attention: Please do not oil these parts when
using our grease.
µ Assembly
3. Carbon Brush Changing: First remove loco
body (fig. 2), and then the motor (fig. 5).
µ Assembly
Assembly: During assembly please take care of
correct position of contacts.
Off you go!
9
Werbung
