Warranty; Accessories And Spare Parts En - Kärcher HDS 6/14 CX Classic Originalbetriebsanleitung

 If detergent tank is empty, refill.
 Check connections and conduits.
Pressure is set to MIN
–
 Set pressure to MAX.
Sieve in the water connection is dirty
–
 Clean sieve.
 Clean the fine filter; replace it, if neces-
sary.
Amount of water supply is too low.
–
 Check water supply level (refer to tech-
nical data).
Device leaks, water drips from the
bottom of the device
Pump leaky
–
Note: 3 drops/minute are allowed.
 With stronger leak, have device
checked by customer service.
Device turns on and off while hand
spray gun is closed
Leak in the high pressure system
–
 Check high pressure system and con-
nections for tightness.
Device is not sucking in detergent
 Leave device running with open detergent
dosage valve and closed water supply, until
the swimmer tank is sucked empty and the
pressure falls to "0".
 Open the water supply again.
If the pump still is not sucking in any deter-
gent, it could be because of the following
reasons:
Filter in the detergent suck hose dirty
–
 Clean filter.
Backflow valve stuck
–
 Remove the detergent hose and loosen
the backflow valve using a blunt object.
Burner does not start
Fuel tank empty.
–
 Refill fuel.
Water shortage
–
 Check water supply, check connections.
 Clean sieve in the water shortage safe
guard.
Fuel filter dirty
–
 Change fuel filter.
No ignition spark
–
 If device is in use and no ignition spark can
be seen through the viewing glas, have de-
vice checked by customer service.
Set temperature is not achieved
while using hot water
Working pressure/flow rate to high
–
 Reduce working pressure/flow quantity
at the pressure/volume regulator in the
pump unit.
Sooty heating spiral
–
 Have device de-sooted by customer
service.
If malfunction can not be fixed, the device
must be checked by customer service.
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of the appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication.
Accessories and Spare Parts
Note: When connecting the appliance to a
chimney or if the device cannot be ac-
cessed visually, we recommend the instal-
lation of a flame monitor (option).
Only use accessories and spare parts
–
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
At the end of the operating instructions
–
you will find a selected list of spare parts
that are often required.
For additional information about spare
–
parts, please go to the Service section
at www.kaercher.com.
– 11
EN

Warranty

33