Starter; High Pressure Lamps And Filter Panels - SOLTRON XXS - 25 series Gebrauchsanweisung

08/2009 1008077-00
5.8.2

Starter

Replace faulty starters immediately.
You can recognise a faulty starter by the blackened ends of the UV low
pressure lamps or when the UV low pressure lamps can no longer be started.
Operating a UV low pressure lamp with a faulty starter significantly shortens
its service life. The UV low pressure lamp loses power and may begin to
flicker under certain circumstances.
The starters are located in either one of the two lamp sockets or are visible
when the UV low pressure lamps are removed. Turn 90° and carefully remove
from the socket.
– Turn 90° and carefully remove from the socket.
5.8.3

High pressure lamps and filter panels

UV high pressure lamps are used in facial tanners.
DANGER!
Fire hazard due to overheated lamps!
Non-approved high pressure lamps can explode. Hot lamp
components can set other parts on fire. People can be killed
or severely injured due to smoke inhalation and fire.
– Only fit the high pressure lamps specified by the
manufacturer.
– Clean the inside of the device regularly. Dust particles
are flammable!
– Open the clamps.
– Lift the filter panel, pull it out of the guide and remove it.
Cleaning and maintenance
Operating instructions – 43