Worx Landroid M Installationsanleitung Seite 14

3. Connect the base to the boundary wire
14
EN
OUT
IN
IN
OUT
3.1
Cut the end of the wire to a length that's appropriate convenient
for reaching the clamps.
NOTE: Too long redundant wire may cause the signal problem.
Strip the two ends of the wire.
3.2
When connecting to the charging base there is an IN wire and
an OUT wire, as shown. Connect the IN-wire to the red clamp
of the charging base and the OUT-wire to the black clamp.
Then close the cover.
NOTE: Please fix the boundary wire around the charging base
firmly with the wire pegs.