Working Instructions; Cleaning And Maintenance; Cleaning And General Maintenance Work - Grizzly BRM 51-2 BSA Originalbetriebsanleitung

Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
Cleaning and
Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and clean-
ing work strictly with the engine
switched off and spark plug con-
nectors removed. Risk of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual sup-
plied.
We recommend contacting an au-
thorised Briggs & Stratton dealer for
maintenance work on the engine.
Cleaning and General Mainte-
nance Work
Tip the Equipment (Service Posi-
tion):
To clean the underside of the
equipment, tip the equipment
backwards on the upper handle
bar (1) .
1. remove the grass collection box
( 18), if it is installed.
2. set the cut height to the highest posi-
tion (17).
3. loosen the quick release tensioning
levers (19) and fold the top handle
bar (1) towards the equipment (see
"Assembling the Handle Bar").
The Bowden cables (28) must not be
caught when doing this.
Ensure that the quick release
tensioning levers (19) come to a
stop on the side.
When cleaning or servicing the
appliance, ask someone to hold
the tilted appliance.
GB
89