Worx sonicrafter WX676 Originalbetriebsanleitung Seite 11

7. SAwING wITH THE SEMIcIRcLE SAw
BLADE
Typical application: wood, plastics, sheet
metal.
Select high oscillation frequency.
The saw blade lasts longer if the wear
is distributed evenly. To ensure an even
distribution, loosen the saw blade, rotate it
and retighten firmly.
8. SAwING wITH THE UNIVERSAL END
cUT SAw BLADE (See Fig. K)
wARNING: the sawing teeth are
very sharp. Do not touch during
mounting and application.
The workpiece must be inserted firmly or
clamped tightly before it is cut.
Typical application: wood, metal (e. g.
nails),plaster board and soft plastics.
When plunging and sawing use a slight
pendulum motion, to allow sufficient chip
removal.
9. ScRAPING
Typical application: Scraping off old varnish
or adhesives, removing glued carpeting, e.
g. on stairs or other small to medium-sized
surfaces.
Select medium / high oscillation frequency
(for variable speed models).
10. SEcURING THE wORKPIEcE
cAUTION: Before working with
your tool make sure that no power
cords will be damaged
Oscillating Tool
11
EN