Options - Atag VA6311SF Benutzerinformation

Programme Degree of soil
1) Type of load
Fresh soil
Crockery and
3)
cutlery
Normal soil
Crockery and
4)
cutlery
Normal soil
5)
Crockery and
cutlery
1) The pressure and the temperature of the water , the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the
temperature and quantity of the water, the energy consumption and the programme duration.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery
with normal soil. (This is the standard programme for test institutes).
5) This is the most silent washing programme. The pump works at a very low speed to decrease the level of noise.
Because of the low speed, the programme duration is long.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

OPTIONS

Multitab option
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid
and salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab
function before the start of a pro-
gramme. You cannot activate or deac-
tivate this function while a programme
operates.
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold function buttons (D) and
(E) at the same time until the multitab in-
dicator comes on.
Programme
phases
Wash 60 °C
Rinse
Prewash
Wash 50 °C
Rinses
Dry
Prewash
Wash 50 °C
Rinses
Dry
The function stays on until you deacti-
vate it. Press and hold function buttons
(D) and (E) at the same time until the
multitab indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Duration Energy
(min) (kWh)
30 0.8
160 - 180 0.8 - 0.9
200 - 220 1.1 - 1.2
19
Water
(l)
9
9 - 10
9 - 11