Timer; After Deep-Frying - Silvercrest SKF 2800 B2 Bedienungsanleitung

Timer

You can programme a countdown of up to 60 minutes with the timer
■ Press the "
■ Press the "+" and "-" buttons to set the desired time in minutes.
■ Press the "
twice to show that the countdown is starting.
You will hear a few beeps on completion of the countdown.
The timer
TIPS
► The heating element
Therefore, take note of the signal tone from the timer
the food.
► When the battery is depleted, replace it. Always use batteries of the same
type. Ensure that the batteries are inserted with the correct polarity.

After deep-frying

1) When the food is ready, pull the handle upwards until the latch handle
engages.
2) Leave the frying basket
3) Press the On/Off switch
the power plug from the mains power socket.
4) When the food has dripped off, open the appliance lid by pressing the latch
handle
WARNING – RISK OF INJURY!
► Never touch the frying basket
hot! Only lift the frying basket
5) Lift the frying basket
off excess oil or grease over the fryer.
6) Tip the fried food into a bowl or a sieve (lined with absorbent kitchen paper!).
■ 12 │ GB │ IE
" button on the timer
" button to start the time countdown. The set time will flash
will switch off automatically.
is NOT switched off when the countdown finishes!
in this position to drip off.
. The deep fat fryer is now switched off. Remove
.
carefully out of the deep fat fryer. If necessary, shake
to switch it on.
directly after deep frying. It will be extremely
out of the deep fat fryer using the handle!
:
to avoid spoiling
SKF 2800 B2