Assembling The Device; Assembling The Frying Basket; Assembling The Fryer; Operation - Silvercrest SEF 2300 B2 Bedienungsanleitung

B53 B)ULWWHXVHB%ERRN 6HLWH  0LWWZRFK   $XJXVW   
7. Assembling the
device
7.1 Assembling the frying
basket
1. Figure C: press the metal brackets on
the handle|17 and put their ends into
the small eyes on the inside of the frying
basket|18.
2. Tilt the handle|17 towards the outside
until it locks in place.

7.2 Assembling the fryer

WARNING!
All parts must be dry and undamaged.
1. Put the oil container|14 into the hous-
ing|15.
2. Insert the base unit|11 at the designat-
ed place on the housing. Let the rails of
the base unit|11 just slide into the open-
ings on the housing|15.
3. The basket|18 and the handle|17
should only be put into the fryer, when
oil and food have already been filled in
(see "Frying" on page 66).

8. Operation

8.1 Setting up

Fire hazard!
~ The mains plug|10 should only be put
into the wall socket after the oil contain-
er|14 has been filled with oil or melted
fat at least up to the MIN marking.
• All parts of the fryer must be completely
dry, when you use the device.
• Put the fryer on a stable, flat, non-slip,
dry, and non-inflammable work surface.
• Do not use the fryer under wall units
and not near to any curtains, paper or
any similar inflammable objects.
• Do not place the device directly under a
wall socket.
• Keep a distance of at least 50 cm on all
sides.

8.2 Filling in the frying fat

Fire hazard / DANGER of
burns!
~ The level of the frying fat/oil in its liquid
state must be between the MAX and
MIN markings on the inside of the oil
container|14.
~ Only fats and oils which are suitable for
frying should be used (see "The basics
of frying" on page 62).
1. Approx. 3.4 (MIN) to 3.6 (MAX) litres
of frying oil or approx. 3.6 kg of solid
frying fat are required.
2. Solid frying fat should first be put into a
pan and melted slowly at a low temper-
ature. Only then it should be poured
carefully into the oil container|14 of the
fryer.
65
GB