English
12
ON
OFF
0 / 8
Manual rinsing cycle
MENU
HOT
WATER
GROUND COFFEE
19 Select ON on the display and confirm the activation by pressing the OK
button.
-
When activation is finished, the display shows a tick to confirm
activation.
-
The machine starts heating up automatically.
-
Then the machine ready screen appears with the AquaClean 100%
icon to indicate that the filter has been installed.
20 Dispense 2 cups (0.5 l) of hot water to complete the activation. Discard
this water. To complete the activation you have to perform both the hot
water circuit rinsing and coffee brewing circuit rinsing.
After installing the AquaClean filter, you do not have to perform the manual
rinsing cycle.
During the manual rinsing cycle, fresh water flows through the water and
coffee brewing circuit. This takes a few minutes.
Hot water circuit rinsing
1 Insert the hot water dispensing spout (if it is not installed) and place a
container under the hot water dispensing spout.
2 Press the MENU button. Select the DRINKS function, confirm and scroll
the menu to select the HOT WATER function. Press the OK button to
confirm.
-
The display reminds you to install the hot water dispensing spout,
press the OK button to confirm.
-
The machine starts dispensing hot water.
Note: To interrupt the rinsing cycle, press the OK button.
3 When the machine has dispensed 2 cups of hot water (0.5 l) press the OK
button to stop the hot water dispensing. Repeat steps 1 to 3 twice.
Coffee brewing circuit rinsing
1 Place a container under the coffee dispensing spout.
2 Press the AROMA STRENGTH button and select the pre-ground coffee
brewing function.
Note: Do not add pre-ground coffee in the pre-ground coffee
compartment.
3 Press the ESPRESSO LUNGO button.
-
The machine starts dispensing water from the coffee dispensing
spout.
4 Wait until the machine stops dispensing water and empty the container.
5 Repeat steps 1 to 4 twice.
6 When the machine has returned to the main menu, empty the
container.The machine is ready for use