Philips Saeco Incanto Bedienungsanleitung Seite 11

-
The display shows the circuit priming icon to indicate that you have to
prime the circuit.
9 Place a container under the hot water dispensing spout. Press the OK
button to start the water circuit priming cycle. The machine reminds you
have to insert the water spout, press the OK button.
-
The machine starts dispensing hot water.
-
The display shows the priming icon. The progress bar shows the
progress of the priming cycle.
10 The machine heats up and the display shows the temperature icon.
11 Empty the container and place it under the coffee dispensing spout.
12 The machine starts rinsing water through the coffee dispensing spout.
The display shows the rinsing icon and a progress bar.
Note: Do not interrupt the rinsing cycle.
13 The display asks: AquaClean filter?
Note:If you want to install the AquaClean filter afterwards, press the ESC
button and continue with the manual rinsing cycle. For installation, see
chapter 'AquaClean filter'.
14 If you want to install the AquaClean filter, press the OK button. Activation
will take 2 minutes.
INSTALL
FILTER
- The display reminds you to install the filter.
15 Remove the AquaClean filter from its packaging. Shake the filter for about
5 seconds.
16 Immerse the AquaClean filter upside down in a jug with cold water and
wait until no more air bubbles come out.
17 Insert the AquaClean filter vertically onto the filter connection. Push the
AquaClean filter to the lowest possible point. Make sure that the filter fits
tightly and the seal is in the right position, to guarantee the best
performance.
18 Fill the water tank with fresh water to the MAX level indication.
English
11