Faema E92 A Compact Handbuch Seite 35

English
2.2 User dose - programming the coffee distribution keys
PROGRAMMING THE COFFEE DISTRIBUTION KEYS
(26, 27, 28 and 29 of group 2)
N.B.: Also valid for group 1 (group on the left as seen by the operator)
only if the CAPPUCCINO function is not activated.
When one of the coffee distribution keys is pressed (shown by the
flashing led), the following message will be displayed:
2.3 User dose - Programming the milk distribution key
PROGRAMMING THE MILK DISTRIBUTION KEY (16)
N.B.: Also valid if the CAPPUCCINO function is not activated.
When the milk distribution key is pressed (shown by the flashing led),
the following message will be displayed:
2.4 User dose - Programming the hot water distribution keys
PROGRAMMING THE HOT WATER DISTRIBUTION KEYS
(13a)
When one of the hot water distribution keys is pressed (shown by the
flashing led), the following message will be displayed:
key 17
To perform the programming of the coffee dose follow the procedure
herebelow:
1) Place a container by the hot water distribution nozzle (10).
2.5 User Dose - Programming the automatic steam key
AUTOMATIC STEAM DISPENSING KEY (12) PROGRAMMING
When the automatic steam dispensing key is pressed (indicated by the
relative led), the following message is displayed:
selection 21
00 °C
10.0
key 07
coffee dose
To perform the programming of the coffee dose follow the procedure
described in Paragraph 2.1.
key 20
To perform the milk dose programming, follow the procedure described
in Paragraph 21.
2) Keep the distributor key pressed, as evidenced by the flashing led
(the hot water dose counter starts from zero and increases in value).
3) When the quantity of water in the container has reached the desired
level, release the key (the counter will indicate the time that
corresponds to the set dose).
It is possible to vary the set dose via the “+” (34) and “-” (35) keys (the
time of the water distribution can also be increased or decreased).
How to perform other operations
The new key is set by pressing the dispensing key.
When the key (33) is pressed, the message “user dose” (Paragraph
4 4 4
2) will be displayed.
When the FRAME DISPLAY (31) key is pressed, the message “clock
program” is displayed (See Paragraph 3).
This key is programmed by setting the temperature via the “+” (34) and
“-” (35) keys between a minimum value of 50° C and a maximum value
of 99° C. When the drink reaches the set temperature, steam dispensing
stops automatically.
How to perform other operations
When the key (33) is pressed, the message “user dose” (paragraph
4 4 4
2) is displayed.
When the FRAME DISPLAY (31) key is pressed the message “clock
program” is displayed (see paragraph 3).
English
200
10.0