Removing And Cleaning The Wire Guides; Replacing The Oven Light Bulb - Pelgrim MAC514RVS Anleitung

CLEANING

Removing and cleaning the wire guides

Replacing the oven light bulb

EN 22
Only use conventional cleaners to clean the guides.
• Remove the screw using a screwdriver.
• Remove the guides from the holes in the back wall.
Make sure the spacers fitted on the wire guides are not lost.
Replace the spacers after cleaning; otherwise, sparks may appear.
The lamp in this household appliance is only suitable for
illumination of this appliance. The lamp is not suitable for
household room illumination.
The bulb (halogen G9, 230 V, 25 W) is a consumable and therefore not
covered by warranty. Before changing the bulb, remove the trays, the
grid, and the guides.
• Remove the cover and the glass by removing the 4 screws.
• Replace the halogen light bulb.
NOTE: Use protection to avoid burns.
NOTE: There is a gasket on the cover which should not be removed.
Do not allow the gasket to be detached from the cover. The gasket
should fit correctly onto the oven cavity wall.
Re-tighten the cover screws firmly using a screwdriver; otherwise,
sparks may appear.