Using The Ice Cream Maker - Medion Micromaxx MD 16223 Bedienungsanleitung

7. Using the ice cream maker

 Place the mixture container into the ice cream maker. .
NOTE
When inserting the mixture container, ensure that the handle mounts lie
in the locking tabs of the cooling unit.
 Place the stirrer in the mixture container and align the stirrer with the position of
the drive hub.
 Mount the motor block into the recess on the cover. Ensure that both tabs snap
audibly into place in the two recesses on the cover.
 Attach the stirrer on the drive shaft.
 Place all the ingredients in the mixture container. Do not exceed the filling ca-
pacity of 500 ml.
 Place the cover together with the motor block onto the mixture container. En-
sure that the locking tabs fit into the recesses and close the mixture container by
turning the cover slightly in a clockwise direction.
 Connect the appliance to a properly installed 220–240 V~, 50 Hz safety socket.
 Press the
button to switch on the appliance.
The operating time of 50 minutes flashes in the display.
You can set an operating time of 50, 40, 30 or 10 minutes.
 Set the desired operating time. You can change the duration of the current pro-
gramme in increments of 5 minutes by pressing the
 Fill the mixture container during operation via the filling opening in the cover.
 After the time is up, disconnect the plug from the mains socket and remove the
cover with motor block and the stirrer.
 Use a spatula to remove the ice cream from the mixture container.
 Remove the stirrer after preparation.
CAUTION!
Do not store finished ice cream in the mixture container.
Use a suitable deep freeze container.
Clean the appliance parts (mixture container, stirrer, cover) carefully as described
below.
68 /78
button.