Mounting the canopy hood above
an island
4
3
5
1
2
6
Make sure that the ceiling is suitable for the
suspension of the construction chimney.
■
First determine the position and distance
with regard to the chimney. Make a 160 mm
hole in the ceiling for the duct.
■
If the opening for the flex (bottom of the
chimney construction 1) is pointed towards
you, then the control switches will be to
your right.
■
Drill four 10 mm holes for the plugs and
screw the chimney against the ceiling.
■
If the hood is to be connected to a 125 mm
diameter flue pipe, the 150/125 mm
adapter (2) must first be attached to the
motor group using 2 screws.
■
Slide the inner cylinder (3) over the
chimney construction up to the ceiling and
fix it with 2 screws (4). Then slide the outer
cylinder (5) on.
■
Fix the canopy hood to the chimney
construction with the 4 M6 screws (6).
■
Make the electrical connection and
observe the flex opening (1).
■
Now fix the outer cylinder (5) to the cooker
hood with 2 screws, this is done from the
inside of the cooker hood.
■
Remove the film from the filters.
Disposal of packaging and
appliances
The packaging of the appliance is recyclable.
It is made up off:
– cardboard
– polyethylene
– CFC free polystyrene (PS rigid foam)
– polypropylene straps around the box
Please dispose of these materials in a
responsible way in accordance with the
regulations of your local authority.
Your local authority will also be able to give
you information about disposing disused
household appliances in a responsible way.
Technical specifications
See identification plate for technical
specifications.