Installing Your Appliance; Using The Evacuation Mode; Using The Recycling Mode - Fagor 9 CFV 92 X Bedienungsanleitung

2 / INSTALLING YOUR APPLIANCE

— The appliance must be unplugged during installation or when any repairs or maintenance
work is being performed.
— Ensure that the network voltage corresponds to the voltage noted on the identifi cation
plate located inside the hood.
— If the electrical installation at your residence requires any changes in order to hook up
your Appliance, call upon a professional electrician.
— If the hood is being used in evacuation mode, do not connect the appliance to a
combustion gas exhaust duct (boiler, chimney, etc.) or to a CMV (controlled mechanical
ventilation) system.
— Under no circumstances should the exhaust duct empty into the attic.
— Install the hood at a safe distance of at least 70 cm from an electric, gas or combined
cooking hob.

• USING THE EVACUATION MODE

If you possess an outlet to the exterior
(pic. 1)
Your hood can be connected to this outlet
using a fl ue (minimum diameter Ø mm that
is enamelled, in aluminium, fl exible or made
of infl ammable material). If your fl ue is less
than 125 mm in diameter, you must use the
recycling mode.

• USING THE RECYCLING MODE

If you do not possess an outlet to the exterior
(pic. 2)
All of our appliances can be used in recycling
mode.
In this case, you should add an active
carbon fi lter which will keep in odours. (See
Chapter 4: Changing the carbon fi lter.)
23
EN
pic.1
pic.2