BH FITNESS G2518i Montage- Und Gebrauchsanleitung Seite 14

1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(1) Monitor.
(13L) Top focus bar, left.
(13R) Top focus bar, right.
(19L) Bottom focus bar, left.
(19R) Bottom focus bar, right.
(23) Main post.
(38) Bottom post cover.
(31) Pedal left foot.
(31) Pedal right foot.
(25L) Left footrest.
(25R) Right footrest.
(51) Bottom cover, left foot.
(51) Bottom cover, right foot.
(75) Rear stabiliser bar with wheels.
(43) Main body.
(95) Front stabiliser
adjustable feet.
(21) Handlebar tube.
(18F ) Monitor front cover
(18B ) Monitor back cover
(116 ) Adapter
Fig.2 - . NUTS & BOLTS
(40) Screws M10x20 .
(34) Flat Washer 8.
(49) Spring washer 8 .
(10) M8x20 screws .
(35) M10 Nut
(34) Washer 10
(28) Screw M10x78
(2) ScrewM5x10
(50) Washer
(5) Screw M5x15
(11) Spring washer 6
(52) Screw M5x7.5
(46) Screw M8x35
(45) Washer 6
Allen wrenches 5mm
Mixed Key.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (95) to the main body (43)
positioning the wheels at the front of
the unit, Fig.3, insert screws (16). Use
the 5mm Allen key to tighten securely.
Take the rear stabiliser bar with
adjustable feet (75), Fig.4, insert the
bolts (16) nd tighten securely.
3. FITTING THE BOTTOM
POST COVER.-
Take the main post (23) and insert the
bottom post cover (38) in the direction
of the arrow, Fig.5.
Now take the control knob (36) and
screw it clockwise onto the boss on the
main
tightening
shown in Fig.5.
bar with
4. FITTING THE MAIN POST.-
Once the bottom post cover is fitted,
remove
washers (34) and axis(41)
bottom of the main post (23).
Bring the main post (23) up to boss on
the main body (43), Fig.6.
Plug connector (3), coming out of the
main post (23), into connector (39),
coming out of the boss on the main
body (43), Fig.6.
Slip the main post (23) over the boss
(43) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Lower the bottom trim section (38) for
the main post (23) down over the boss
section of the main body (43), Fig.6.
14
body (43) with
securely,
the 2 screws
screw(37),
positioned as
(40) and
from the