ZyXEL Omni 56K Benutzerhandbuch Seite 54

Command
+FK
+FLID="string"
+FLO=n
+FLPL=n
+FMDL?
+FMFR?
+FMINSP=n
+FPHCTO=
<value>
+FPTS=n
+FREL=n
+FREV?
+FSPL=n
Table 2.
All other +F commands are not supported, but the modem will respond OK. In
many cases this means "don't care."
5-14
Benutzerhandbuch für ZyXEL Omni 56K und Omni 56K Plus Modem
Description
Procedure interrupt; another page follows.
Procedure interrupt; end of document, another document follows. n=5
Procedure interrupt; end of document.
Regular fax abort command.
Local ID string parameter.
Flow control options:
No flow control.
Set XON/XOFF software flow control.
Set CTS/RTS hardware flow control.
Document for polling command:
The DTE has no document available for polling.
Indicate a document available for polling.
Request DCE model .
Request DCE manufacturer .
Minimum phase C speed parameter:
2400 bps.
4800 bps.
7200 bps.
9600 bps.
12000 bps.
14400 bps.
DTE Phase C response time-out:
Determine how long the DCE will wait for a command after
reaching the end of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
Page transfer status
Received page good.
Page bad; retrain requested.
Page good; retrain requested.
Page bad; procedure interrupt requested.
Page good; procedure interrupt requested.
Phase C received EOL alignment:
The EOL patterns are bit aligned as received.
The last received bits of EOL patterns are byte aligned by the
DCE, with necessary zero fill bits inserted. Refer to TIA PN-2388
for details.
Request the DCE revision identification.
"Enable polling" command:
Disable polling.
Enable polling.
Supported Commands (per TIA PN2388 8/20/90)
Value
n=4
n=6
n=0
n=1
n=2
n=0
n=1
n=0
n=1
n=2
n=3
n=4
n=5
0-255
n=1
n=2
n=3
n=4
n=5
n=0
n=1
n=0
n=1