Gastroback 46007 Bedienungsanleitung Seite 32

on sloping or wet surfaces or where it can fall.
space of 20 cm to the sides and 1m above the appliance should be left for suf-
ficient ventilation. Do not place any cloth or tissue under or on the appliance, to
avoid any risk of fire, electric shock or overheating. Do not use the appliance in
wet or humid areas.
• After each sealing process let the appliance cool down for approximately 30
seconds (with lid left open) before starting again. Only use the designated foils,
bags and containers with the appliance to avoid damage. Ensure that the appli-
ance will not suck in any liquid or powder.
• Do not vacuum pack inflammable liquids (e.g. alcoholic beverages,
solvents).
building-up a hazardous explosive mixture. Additionally, the appliance will get
damaged.
• Containers used for vacuuming may not have any cracks and scratches. Thus,
carefully check all containers used with the appliance for perfect condition. Do
not use any other than the designated containers. Damaged or unsuited contai-
ners can burst under vacuum with splinters hurled about! Always handle containers
under vacuum with special care, to avoid bursting. Do not consume any food from
a crushed container, because splinters could be in the food, thus causing severe
injuries.
• Do not leave the appliance unattended while connected to the
power supply.
cooled down, before moving, or cleaning, or when the appliance is not in use. Do
not grasp the appliance at the open lid or power cord for moving the appliance.
• Always unplug and wait for the appliance to cool down, before cleaning or sto-
ring. Close the lid to protect sealing band and gaskets for moving or storing.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or
any corrosive chemicals (e.g. bleach) for cleaning. Do not immerse the appliance
or power cord in water or any other liquid. Do not spill or drip any liquids on the
appliance, or on the power cord to avoid risk of fire and electric shock. When
liquids are spilled in the motor housing or sucked in, immediately switch OFF the
appliance (STOP button), unplug the appliance, and wait for the appliance to
cool down. Thereafter, clean and dry the appliance thoroughly. (See: Care and
Cleaning)
• DO NOT place the appliance or any parts in an automatic dish-
washer.
32
Caused by low pressure, large amounts of liquid will evaporate, thus
Always unplug the appliance, and wait until the sealing band
During operation free