Operating And Functional Elements - Kärcher KM 170/600 R D Kurz- Betriebsanleitung

Operating and Functional El-
ements
Function keys
1 Beacon lamp on/off
2 Horn
3 Blinker switch
Multi-functional display
1 Operating hour counter
2 Charge warning lamp
3 Oil pressure warning lamp
4 Cooling water temperature warning
lamp
5 Motor suction air
6 Warning lamp fuel reserve
7 Preglow indicator light
8 Indicator lamp (not connected)
9 Indicator lamp for sidelights
10 Indicator lamp for dipper
11 Indicator lamp for directional indicator
12 Indicator lamp - forward driving direc-
tion
13 Indicator lamp - reverse driving direc-
tion
14 Tank indicator
Operating elements
1 Drive pedal
2 Brake pedal
3 Tank door
4 Parking brake
5 Blower lever
6 Horn/lighting/blinker (option)
7 Steering wheel
8 Ignition lock
Ignition lock
1 Warning system (option)
2 Ignition key
Filament symbol : Pre-heat
–
Position 0: Switch off engine
–
Position 1: Ignition on
–
Position 2: Start the engine
–
Start up
General notes
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Refuelling
Danger
Risk of explosion!
Only use the fuels specified in the Op-
–
erations Manual.
Do not refuel the machine in enclosed
–
spaces.
Smoking and naked flames are strictly
–
prohibited.
Ensure that no fuel reaches the hot
–
open surfaces.
 Check fuel level via the tank indicator.
 Switch off engine.
 Open the side engine panel.
 Open fuel filler cap.
 Fill in diesel.
 Wipe off any spilt fuel and close fuel fill-
er cap.
Operation
Programme selection
1 Transport drive
2 Sweeping with sweep roller
3 Sweeping using roller brush and side
brushes
2
-
EN
Lock/ release parking brake
 Loosen parking brake; press brake
pedal at the same time.
 Activate the parking brake; press brake
pedal at the same time.
Adjusting driver's seat
 Pull seat adjustment lever outwards.
 Slide seat, release lever and lock in
place.
 Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Starting the machine
Note:The machine is equipped with a seat
contact switch If the driver's seat is vacat-
ed, the machine is switched off.
1 Blinker switch
2 Parking brake
3 Motor speed adjustment
 Sit on the driver's seat.
 Bring the direction selector switch into
the middle position.
 Lock parking brake.
 Engine speed adjustment - push for-
ward by 1/3.
Pre-heat
 Insert the ignition key into the ignition
lock.
 Turn the ignition key to position "Fila-
ment".
Pre-heat lamp glows.
Start the engine
 When the pre-heating lamp goes off,
turn the ignition key to position "II".
 If the machine starts, release the igni-
tion key.
Note: Never operate the starter motor for
longer than 10 seconds. Wait at least 10
seconds before operating the starter motor
again.
Drive the machine
 Set programme selection switch to
"Transport drive". .
 Move the gas lever all the way to the
front (high speed).
 Press brake pedal and keep it de-
pressed.
 Release parking brake.
Drive forward
 Set the travel direction switch to "for-
ward".
 Press accelerator pedal down slowly.
7