Teaching In To A Homematic Ccu - HomeMatic HM-Sec-SC-2 Montageanleitung

• Abort with a short press of the teach button, the
device LED will then illuminate in red.
• If no teaching occurs, teach-in mode is automati-
cally ended after 20 seconds. If other devices are
in teach mode, these are taught.
• Now put the device you wish to teach-in the
shutter contact into teach-in mode. Please follow
the relevant operating manual instructions of the
corresponding device.
• If learning is completed successfully, it is indica-
ted with the flashing green LED.
If no teach-in is carried out, teach-in mode will be
exited automatically after 20 seconds. If other
devices are also in teach-in mode, they will be
taught-in.
48
If the sensor is already taught for a center and
therefore is blocked for direct training, it can
still be put in teach mode as described above
but no teaching occurs and the device LED is
illuminated in red for two seconds.

7.2.2 Teaching in to a HomeMatic CCU

Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control programs
via the HomeMatic software „WebUI". Therefore, your
shutter contact has to be taught-in to the HomeMatic
Central Control Unit first. New devices are taught-in to
the Central Control Unit via the HomeMatic „WebUI".
A soon as a component has been taught-in to a
Central Control Unit, it can only be connected to
other components via the CCU.
Each component can only be taught-in to one
Central Control Unit.
49