Teaching-In To Homematic Devices; Teaching In To A Homematic Ccu Your Device Can Be Conveniently - HomeMatic HM-LC-Dim1TPBU-FM Bedienungsanleitung

8.2.1 Teaching-in to HomeMatic devices

If you would like to teach-in the actuator to one or
more HomeMatic devices, you must put the devices to
be taught-in into teach-in mode and select the required
teach-in channel. To do this, proceed as follows:
During teach-in, please make sure you maintain
a distance of at least 50 cm between the de-
vices.
• Briefly press the Config button of the actuator with a
pointed object (e.g. ballpoint pen) to start the 20-se-
cond teach-in mode again.
• Flashing of the LED in the Config button indicates
that teach-in mode is active.
• Now put the device you wish to teach-in the actuator
into teach-in mode and select the required channel
button if necessary. Please follow the relevant opera-
ting manual instructions of the corresponding device.
• A soon as both components have completed the
teach-in procedure, the LED's go off and the actuator
can be operated via the transmitter in a standard
configuration.
62
If no teach-in operations are carried out, teach-
in mode will be exited automatically after 20 se-
conds.
If other devices are also in teach-in mode, they
will be taught-in.
8.2.1 Teaching in to a HomeMatic CCU
Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control programs
via the HomeMatic software „WebUI". Therefore, your
actuator has to be taught-in to the HomeMatic Central
Control Unit first. New devices are taught-in to the
Central Control Unit via the HomeMatic „WebUI".
A soon as a component has been taught-in to a
Central Control Unit, it can only be connected to
other components via the CCU.
Each component can only be taught-in to one
Central Control Unit.
During teach-in, please make sure you maintain
a distance of at least 50 cm between the Home
63